Alto-Extremo Lyd I
Sorry, this product is temporarily out of stock.
Alto-Extremo Lyd I
Alto-Extremo's most successful absorber can be used optimally in every system. The superior design with precision brass interior components and stainless steel exterior parts, as well as the two damper rings, create excellent resonance transfer without allowing any vibrations to reach the base of the device. This function is necessary for higher bass precision and for an open and clearly distinguishable sound profile.
Set of three: US $379.-
Set of four: US $479.
The Lyd Technology
Lyd technology makes these absorbers very flexible. With the outer damping ring the absorber’s effect is magnified. Try the absorber with the damping ring on the device as well as on the surface itself. Try the absorber with the damping ring side to the ground and you minimize vibrations from the device and disconnect the ground. If you use the absorber with the damping ring side to the device you disconnect the device and minimize vibrations from the ground.
The self-adjusting puck compensates for uneven floor surfaces. The inner component is flexible. They can tilt to the side, if the floor is uneven. If you have an older wooden floor or a uneven tile ground, the Lyd and Exact can compensate that. That's no height adjustment.
The German magazine STEREO tested the Lyd I absorber feet:
"...three Lyd I Absorbers were used for each Dynaudio. Compared to the inexpensive Creativ spikes they are truly high tech. What can I say? The Focus 220 performed so incredibly I could hardly believe it. Not only was the spectrum yet again truly impressive, but subtle differences in timing could be more clearly discerned than ever, which made the sound reproduction significantly more detailed and multi-layered. We couldn't believe it, so we put back the Creativ spikes and restored the original settings and even played different kinds of music. The result was the same: on the Alto-Extremo absorbers, the Dynaudio played at a superior level..."
- 30 mm high
- 49 mm diameter
with M8 thread
Weight: 350g each (12 oz)
- 100 kg per absorber